What does Damotech look for when inspecting a new rack installation?

Damotech's engineers can be called-upon to inspect a new racking installation.

When they do, they take the same care in inspecting the racking system. Here are some of the inspection points covered during this type of inspection. It varies for drive-in or cantilever rack systems.

  • Visual inspection of all floor anchors
  • Visual inspection of all beams, safety pins, safety bars, wire mesh (every level)
  • Spot check the torque on anchors or bolts (when applicable)
  • The verticality of uprights (out-of-plumb in cross-aisle and down-aisle directions)

Typical bolt and anchor torque tolerances may vary according to product and manufacturer.